How to deodorize police boots and duty belts

Everyone worries about the vest, but the boots and the duty belt are quietly some of the worst offenders. Your feet sweat all shift inside closed leather. Your belt sits against your body for hours holding heat and moisture. Neither one goes in the wash, so the smell just compounds day after day until the whole locker announces itself when you open it.

Here is how to deodorize police boots and duty belts the right way, so your gear stops carrying the shift into the next one.

Quick answer: how do you deodorize police boots and a duty belt? Dry them out fully between shifts, then treat them with an odor eliminator built for gear you can't wash, like Arrest My Vest. It uses OAM Technology to neutralize odor on contact instead of masking it. Spray the inside of the boots and the full belt, and let them air out.

Why boots and belts smell worse than you think

Boot odor is a moisture problem. Feet sweat a surprising amount, that sweat soaks into the lining and insole, and bacteria feed on it in a warm, dark, closed space. That is the recipe for the smell that hits you when you pull them off.

Duty belts are leather or nylon pressed against your body for the entire shift. They soak up sweat and body odor and have no way to dry out if you leave them coiled in a bag. Powders and sprays that only add fragrance do not fix any of this. They just sit a scent on top of the problem.

Step one: dry them out

Odor needs moisture. Take the moisture away and you starve it.

• Pull the insoles out of your boots after a shift and let both air dry.
• Never seal damp boots or a sweaty belt in a locker or duffel overnight.
• Give everything room to breathe. Airflow is your first line of defense.

Step two: eliminate the odor at the source

Drying helps, but it does not remove the odor that is already in the material. For that you need to actually break the odor down, not cover it.

Arrest My Vest is powered by OAM Technology, short for Odor Absorbing Molecules. The OAM molecules bond to odor particles and break them down the instant the spray hits the surface. The smell is eliminated, not masked, and it works on contact so there is no waiting. You can read how OAM works here.

For boots:

1. Remove the insoles.
2. Spray the inside of each boot, the insoles, and the tongue.
3. Let them air out before your next shift.

For duty belts:

1. Uncoil the belt so you can reach the whole thing.
2. Mist the full length, inside and out, focusing on the areas that sit against your body.
3. Let it breathe before you store it.

Because the formula is designed to be safe on skin, on ballistic materials, and around K9s, it is gentle enough to use across your entire loadout, from boots and belt to the vest carrier.

Make it a two minute habit

Keep a 16 oz bottle in your locker and a 4 oz in your bag. A quick pass at the end of each shift keeps odor from ever setting in, and that is far easier than trying to rescue gear that already reeks. Choose any scent, from deep Midnight to clean Driftwood, or go completely fragrance free with Unscented.

Trusted by the people who wear the gear

More than a million bottles sold. Trusted by police, military, corrections, and first responders nationwide for more than a decade. It earned the go to spot the hard way, one locker at a time.

Get the funk out of your boots and belt for good. Shop Arrest My Vest